Key Words:

air suspension tank

train horn tank

1.5 gallon air tank

seamless aluminum air tank

air tank

Specification:

Material: Aluminum

Thickness: 3.5mm

Max. working pressure: 200 psi

Length: 360mm

Diameter: 168mm

Height: 190mm

Port 1/4NPT: 3

Port 3/8NPT: 2

NW/GW kg: 2.2/2.7

Packing: 37x19x19cm

Included:

1 x air tank

2 x Mounting Feet

Your air tank comes with 3 ¼” NPT and 2 3/8” NPT port openings to allow installation in many positions on your vehicle. To insure safe and trouble-free use of your air tank, we strongly recommend that you install a drain cock and a safety pressure relief valve on your air tank. 

IMPORTANT: 

a.Tank is rated for 200 PSI maximum working pressure.  Do not overfill. Overfilling may result in death or serious injury.

b.Tank is not to be used as a breathing device.

c.Always wear ANSI approved safety glasses when operating air tank.

d.Bleed pressure from tank after each use, and before servicing or adding attachments. 

e.Use only attachments or tools rated for 200 PSI working pressure or less.

CAUTION!  DO NOT PRESSURIZE YOUR TANK UNTIL YOU HAVE INTALLED ALL NECESSARY PORT FITTINGS AND ACCESSORIES.

a.Apply sealant to threads of fittings prior to assembly and tighten each part with a wrench.

b.Do not over tighten if your port fittings are made from brass, since brass threads can be stripped.  The fittings need to be only air tight.

c.Always release air from tank before servicing or repairs. 

WARNING: DRAIN TANK AFTER EACH USE. FAILURE TO DRAIN TANK AND REMOVE CONDENSATION WILL CAUSE TANK TO RUST PREMATURELY.    

a.To remove any accumulated condensation inside the tank, bleed pressure from tank until pressure is approximately 5psi to 20 psi.  

b.   Drain water from tank by opening the drain cock drain valve.

c.If drain cock valve is plugged, release all air pressure from tank, remove drain valve and clean, then reinstall.   

After water has been drained, close the drain cock.